Tom Binns’ Au Fait earrings make a splash in brilliant neons!
You will need…
Fiddly in places but otherwise a no-sew, no-fuss way to recycle picture hooks and add some painterly pops of colour in the winter gloom!
Hard to tell as I had other distractions but I’d say 30-45 minutes, excluding glue and paint drying times.
Take four of your six picture hooks and separate out the lower sections on them (these bits are for hanging so they should be flat and sort-of oblong when you cut them out); then, cut away the top sections (these are the bits with the holes where you should cut them with your pliers, so they should end up with jagged edges).
With the two remaining hooks, straighten out the lower bends and the curls of the top sections but keep the upper bends intact so they’re at a right angle.
Mix your araldite and put the pieces in place like they are on the original – with the longer oblong bits at the top and the jagged-edged bits at the bottom. Mix and use your araldite piece by piece as it hardens extremely quickly (especially the one I used).
Glue your earring studs at the tops of the hooks. I threaded mine through the lower of the two holes and stuck them in place. After the glue has set, curl your top bits over the studs so that those parts of the hooks look like they did before.
When your glue is completely dry (which may take several hours) paint on your design; after that has dried, coat it with 1-2 layers of clear lacquer or nail polish.